Nearly all of the time, companies will spend lots of money to buy their forklifts. It is important, therefore to take proper care of your equipment to protect your investment into the long run. It is a great idea to know the procedures that are undertaken in the care and maintenance of this piece of equipment.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is running. For example, if there are any knocks or misses, the machine is defective and this should raise several concerns. Additionally listen closely for any squealing sounds which come from the belts as these noises will provide you with a lot of information.
When performing maintenance, several of the main components you will have to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also vital to inspect the wiring.
When the above parts have been inspected thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each cell of the battery has to be checked so as to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and after that change the filters. The transmission filter, fuel filters and the hydraulic filter need to be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
Once the oil change has been done and new filters have been fitted, visually inspect the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Then, check every other part of the equipment like the wheels. If any kind of concern or fault is detected, be certain to deal with it immediately in order to make certain the equipment is working at its safest and optimum levels.